Setting up my quad and discovered an interesting issue. Two of the four speed controls (Turnigy Plush 18a) will not initialize from the gluonpilot pwm output. I've swapped the outputs around, recalibrated multiple ways, reprogrammed the escs.... Each seems normal when connected directly to the receiver but two of the four behave as though they are getting no pwm signal on the gluonboard.
The two escs that are working will initialize on any of the four gluonboard pwm outputs. The other two will not initialize on any output, and exhibit no beeps when I try to calibrate them directly from the gluonboard.
Wondering now if there is a tolerance issue - pwm pulse voltage insufficient or frequency too high. I'll keep looking at it and try to narrow down the problem.