I recieved my new revision 'o' board from Unmanned Tech this weekend (very quick service). The board confused me a little while until I eventually found a page showing the 'o' revision hardware
Quick and easy to fire up using the FTDI lead and GluConfig 0.6. GPS data looking good but I'm having issues with some of the other sensor readings:
Pressure sensor is recording a pressure of 10331 Pa resulting in an altitude of 19880m. Temperature starts a little above room temperature but slowly climbs to upwards of 32ºC which is a little higher than the 19ºC it actually is indoors. I'm actually at sea level and the weather forecast is for a pressure of 1033.7hPa.
The board has the 0.7.0 software preloaded and was bought assembled and tested so I'm sure it is simply a case of me doing something wrong somewhere.
Dave