Re: How to build the GluonPilot code
Posted: Mon Nov 14, 2011 10:33 pm
1) That's the original idea ... and I can't think nothing more easy then set +5v or +0V on the channel 6.
2) No way ...
3) Problem is that FrSky by default is sending data from RX to the TX module, but nothing from TX to the RX, so by default it is only a display. This means in FrSky mode there is no way to send any data over the serial port, while the GCS is bidirectional ... so it is hard to detect one from the other.
I will implement the option 1 ... I will send to you the code in case you want to add into the main build stream
Tchuss
e_lm_70
2) No way ...
3) Problem is that FrSky by default is sending data from RX to the TX module, but nothing from TX to the RX, so by default it is only a display. This means in FrSky mode there is no way to send any data over the serial port, while the GCS is bidirectional ... so it is hard to detect one from the other.
I will implement the option 1 ... I will send to you the code in case you want to add into the main build stream
Tchuss
e_lm_70