Hi Tom,
Finally I found time to start playing with my module (SN 13). Unfortunately there is no information displayed on sensors tab. Initialization seems to be ok. See below what I got with a terminal program. There is nothing else after the last 'done'. Same thing with Gluon Config even with "Hide parsed lines" checkbox unchecked. Just in case I uploaded the last firmware available on Google code. No change.
The red led blink 2 or 3 times per second, I can read/write/burn the config from/to the module, etc etc.
Did I miss something ?
Thanks
Pierre
Gluonpilot v0.4 ALPHA [Aug 6 2010 17:48:23, config: 228 bytes, logline: 56 byte
s, navigation: 504 bytes, double: 4 bytes]
A Brown-out Reset has occurred
A Power-up Reset has occurred
2 MB flash found
Loading configuration...done
Opening GPS...timeout...done
Control task initializing...Sensors task initializing...done
Gps task initializing...done
Console input task initializing...done
Datalogger task initializing...done
Telemetry task initializing...done
done