Am i going about this all wrong? Right now i would like to trim my plane for manual flight. I started with a clean setup, no mixing at all... The control surfaces move in the right directions (Delta+), but the travel is far too much.
How do i go about fixing that?
The Manual says:
- Code: Select all
Now (and during the manual-only flights) is the time to trim your servos with your RC-transmitter. DONT program expo or limit the min/max throws of the servos in your transmitter!
I am pretty used to flying with Expo... and if i can´t limit the min/max throws.. how am i supposed to get a flyable plane?