Gluonpilot

Posted: **Sat Feb 12, 2011 4:06 pm**

I tried to get my board (39) running ...
Communication to PC is working, but I can't get the plane level.
There is always more then minus 1 G on Z-axis accelerometer.

I tried already different firmware versions, different configuration tools too ...
Version 0.5.1 brings funny height and temperature too

What is wrong here?

: v51.jpg (101.84 KiB) Viewed 5343 times

Posted: **Sat Feb 12, 2011 7:06 pm**

Hi Tom,

Did yu calibrate the module? You can find on the wiki how to do it: http://gluonpilot.com/wiki/Stabilized_f ... he_sensors

Posted: **Thu Feb 17, 2011 6:46 pm**

Tom,

Were you able to solve your problem?

Gluonpilot

always motion on z-axis

always motion on z-axis

Re: always motion on z-axis

Re: always motion on z-axis