Gluonpilot

After a few evenings of work I got most of the pilot working. I have not much soldering experience but got all the connectors and cables hooked up and feel quite pleased with the result. The servo's are moving in manual mode from PCM receiver signal so that's a good start!

I just bought an EasyStar plane to play around with the gluonpilot, which fits perfectly in the fuselage. This simple plane has only rudder and elevator. I am not sure how to configure this setup e.g. shall I connect the rudder servo to roll or yaw output? Shall I connect the rudder rx input to rudder or rol input on the GluonPilot? On my transmitter I control the rudder with my aileron stick because the ailerons are missing. I know this does not really important but it just demonstrates that from control perspective there is not much difference.

Setup tips are welcome!

Thanks!
Marc

Hi Marc,

Good news!

About the rudder: the gluonpilot only uses the elevator and aileron s(for stabilization and navigation). So an option would be to put the rudder on the roll output. Personally, I modified my easystar with ailerons

Tom