Frsky CPPM PPM input
Posted:
Tue Apr 24, 2012 1:06 pm
by ivanhoes
Sombody tried to use the Frsky PPM receiver with success?
I am not getting any data in the gluonconfig when connecting via the PPM CPPM.
Re: Frsky CPPM PPM input
Posted:
Wed Apr 25, 2012 7:26 pm
by Tom
I don't have such a receiver to test it... Do you have a scope?
Re: Frsky CPPM PPM input
Posted:
Fri Apr 27, 2012 5:32 pm
by ivanhoes
No, unfortunately not...
But maybe this could help? It is the manual with a picture showing some scope-similar information
http://www.frsky-rc.com/uploadfile/201204/20120426092731979.pdf
Re: Frsky CPPM PPM input
Posted:
Sun Apr 29, 2012 5:16 pm
by Tom
Hmm sorry, seems like the way it should be...
Without a frsky receiver it will be hard for me to find out the problem
You'll have to use PWM
Re: Frsky CPPM PPM input
Posted:
Sat Jun 30, 2012 9:54 am
by Schaltkreis
The Frsky CPPM Signal has High level 3,3V and Low level 0V.
One Frame is only 18ms long. So it is possible, that the overlong startpulse is shorter than a channel pulse, if all the channels have long pulses at the same time. you can mesure from rising edge to rising edge or from faling edge to falling edge, it should be the same.