Xbee Pro 2.4ghz
Posted: Mon Mar 07, 2011 6:40 pm
Hi,
I wanted to move the XbeePRO module who where on my mikrokopter ( at 57600 bds)
to the quad I am trying to build whith the Gulon pilot.
I tough it would be easy. because it was already working on the mikrokopter.
So did modification on the sparkfun xbee board . ( no problem to short the diode )
I just changed the baud rate to 115200.
But it didn't work at all.
on the X-CTU utility everything seems normal both module communicate whi good RSSI.
But when used with the gluon pilot .I receive erroneous messages on the console on start-up like the boaud rate should not be good?
Has anybody an idea or already tested the gluon with 2.4 xbeepro ( so not the 2.5 version ).
Thanks
I wanted to move the XbeePRO module who where on my mikrokopter ( at 57600 bds)
to the quad I am trying to build whith the Gulon pilot.
I tough it would be easy. because it was already working on the mikrokopter.
So did modification on the sparkfun xbee board . ( no problem to short the diode )
I just changed the baud rate to 115200.
But it didn't work at all.
on the X-CTU utility everything seems normal both module communicate whi good RSSI.
But when used with the gluon pilot .I receive erroneous messages on the console on start-up like the boaud rate should not be good?
Has anybody an idea or already tested the gluon with 2.4 xbeepro ( so not the 2.5 version ).
Thanks